Black HDPE Sheet 20mm Thick for Machining and Heavy Duty Use

Thick 20mm Black HDPE Panel Built for Machining and Wear Parts

A 20mm slab of black PE300 polyethylene gives you real thickness without the weight of metal. At a specific gravity of 0.96 it is light enough to lift, carry and fit by hand, yet it stays rigid and tough under load. The surface is naturally slippery, so parts glide smoothly, resist scuffing and wear down slowly over time. This grade also shrugs off many chemicals and takes in very little water, which keeps its size and strength steady in wet, washdown or outdoor settings. It keeps its impact strength in the cold and works across a range of minus 50°C to 80°C. Because it is food compliant and cuts, drills and routes with standard tools, it suits both workshop builds and hygienic production areas.

Key Feature

• Material: PE300 high density polyethylene
• Colour: Black
• Thickness: 20mm
• Specific gravity: 0.96
• Temperature range: minus 50°C to 80°C
• Holds up in freezing conditions
• Light weight for easier lifting and transport
• Very little moisture uptake, so it stays dimensionally stable
• Dependable electrical insulating behaviour
• Smooth sliding surface with strong chemical resistance
• Food compliant for hygiene sensitive areas

Where This Thick HDPE Panel Works Best

• Pump housings, guides and wear pads
• Tank fabrication and fittings
• Gasket and seal blanks
• Medical equipment components
• Food processing parts such as cutting surfaces and chutes
• Machined blocks, spacers and bearing plates

Pick this 20mm black HDPE panel when you need a strong, easy to work plastic that lasts. Order today for fast delivery.